Autonics LP-S070 - Diagnosis Code Table

11 Appendix
170 © Copyright Reserved Autonics Co., Ltd.
Name GP device LP device
Applied model
LP-S044 LP-S070
Step operation generated error (Retaining)
UW6521 F121
● ●
Error step UW6530 F130
● ●
Break step UW6531 F131
● ●
Self-diagnosis error code UW6540 F140
● ●
Time setting (Year)
UW6550 F150
● ●
Time setting (Month)
UW6551 F151
● ●
Time setting (Date)
UW6552 F152
● ●
Time setting (Hour)
UW6553 F153
● ●
Time setting (Min)
UW6554 F154
● ●
Time setting (Sec)
UW6555 F155
● ●
Time setting (Day)
UW6556 F156
● ●
Input filter settings UW6560 F160
● ●
Time-driven run-time settings UW6561 F161
● ●
Watchdog timer settings UW6562 F162
● ●
Time-driven interrupt cycle settings 1 UW6570 F170
● ●
Time-driven interrupt cycle settings 2 UW6571 F171
● ●
Time-driven interrupt cycle settings 3 UW6572 F172
● ●
Time-driven interrupt cycle settings 4 UW6574 F174
● ●
Time-driven interrupt cycle settings 5 UW6575 F175
● ●
Time-driven interrupt cycle settings 6 UW6576 F176
● ●
Time-driven interrupt cycle settings 7 UW6577 F177
● ●
Time-driven interrupt cycle settings 8 UW6578 F178
● ●
11.3 Diagnosis code table
 Display self diagnosis error code: It saves error codes which correspond with error lamp
flash and appropriate module code.
 Self diagnosis code: When operating PLC program, it executes ‘refresh input–executing
program–refresh output–self diagnosis’ repeatedly. The latest detected error is displayed
(UW6540) to self error code special device[F140] according to following error code during
executing self-diagnosis.
UW6540(F140) Type Cause of error
0X0010 Watchdog error Scan time excesses watchdog timer setting value
0X0020 Memory error
When a certain area of memory is the un-
approached state.
0x0021 Battery error When battery value is below the standard level
0x0022 RTC setting error Disable to set RTC and RTC operation error
0X0030
Program instruction
error
When the program contains instructions that are not
able to read and inappropriate forms.
0X0031 Program sequence When there is not the instructions required to