Autonics LP-S070 - Repair and Check; Change Repair Component; Battery Change

To Next Page

To Previous Page

10 Repair and Check

10.1 Change repair component

10.1.1 Battery change

Battery of LP-S070 is available for maintain user-defined setting, data backup of latch area, and

time if there is unexpected power failure or it is not able to supply power. You need to change

battery regularly.

(1) The status with discharged battery

 When time is not correct.

 After power failure, time is reset.

 After power failure, data of latch area is reset.

(2) Battery residual quantity display

You can check battery remaining from [Diagnostics]-[Battery remaining] of system setting

menu in LP-S070. Please replace battery if battery remaining is below 5%.

No.

Function and operation

①

Displays battery remaining with 0 to 100% as numerical percentage.

②

Displays battery remaining with bar graph

(3) Special register for battery

Current backup battery error

[F0002C]

Turns ON when battery voltage is below than standard

value

Maintain backup battery error

[F0002D]

If current backup battery error turns ON at once, it

maintains ON status before restarting LP-S070.