6 System Screen
76 © Copyright Reserved Autonics Co., Ltd.
6.4 Environment
6.4.1 Serial communication
This menu displays connected device to RS232C, RS422 port of LP-S070. You can designate
station and connected port by each channel.
No. Function and operation
①CH1 configuration
line
Displays connected device and connect port for CH1.
Touch this to select one from downloaded protocol in GP Editor,
EDITOR, PRINTER, BARCODE, UNIVERSAL, or DEFAULT protocol
and designate connect port. (Select RS232C/RS422 or RS232C-A /
RS232C-B).
Depending on CH2 setting, CH1 may be changed as ‘No Use’.
②CH2 configuration
line
Displays connected device and connect port for CH2.
Touch this to select one from downloaded protocol in GP Editor,
EDITOR, PRINTER, BARCODE, UNIVERSAL, or DEFAULT protocol
and designate connect port. (Select RS232C/RS422 or RS232C-A /
RS232C-B or depending on CH1 setting, CH2 may be changed as ‘No
Use’.)
If CH1 is SLAVE, MONITOR does not appear.
③LP station
configuration touch key
Touch this and input key pad for station appears.
LP station set range: 0 to 31
④Configuration touch
key by each channel
Designate communication details of connected port for CH1 and CH2.
You can designate baudrate, data bit, parity, stop bit, and flow control.
To Next Page
Loading...