6 System Screen
86 © Copyright Reserved Autonics Co., Ltd.
6.4.6 Assistance setting
This menu is for selecting the position of system setting menu key and designating UW device
value LATCH function, buzzer on/off, screen open time, or off time of back light.
①,
②
Check or select the position of system setting menu key to enter from user screen.
①: Displayed that this position is already designated for system setting menu key.
②: Displayed that this position is not designated for system setting menu key.
You can designate system setting menu key up to two keys. If two keys for system
setting menu is set, you should touch both two keys simultaneously to enter system
setting menu.※1
③
Designate buzzer on or off for touch key operation, numeral or ASCII input touch, system
setting menu touch, communication start and complete, or alarm.
Touch this, rotates Buzzer On or Buzzer Off.
④
Menu for set time of open screen when supplying power.
Touch time displayed position and numeral input key pad appears to enter setting time.
Setting time: 0 to 60 sec
⑤
Designate back light off time.
If there is no touch on screen of GP/LP until off time of backlight, LCD backlight is OFF.
Backlight is ON again when user touches it. In this case touching is only for backlight ON
and the other operation is not valid.
Touch time displayed position and numeral input key pad appears to enter setting time.
Setting time: 0 to 60 min. (If 0 is set, backlight is not OFF.)
Depending on the status from [System information device]–[Backlight control bit of read
device] in LP–S070, controls the designated operation.
Backlight setting and operation is available only when backlight control device is SET
To Next Page
Loading...