4 System Organization
64 © Copyright Reserved Autonics Co., Ltd.
3rd Designate communication method.
① Serial setting: Select [Serial Communication] menu, check that CH2 configuraiton is
as‘EDITOR’, and connected connection port with LP-S070 is as ‘RS232C’.
If the configuration is not as ‘EDITOR’, touch (PROTOCOL) part and cofigure as ‘EDITOR’.
Touch this, it rotates in order as EDITOR → PRINTER → BARCODE → MONITOR.
Touch (PORT) area to configure the connection port of LP-S070.
Touch this, it rotates in order as [RS422] and [RS232C].
To Next Page
Loading...