In the Event of a Fire Alarm
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 30
Step Actions to be taken Display Indication Audible Indication
will appear to the left of
each the selected
points).
To multiselect points
one-by-one, press the
Select button to mark a
point, then scroll to
another point in the list
and press the Select
button once more to
mark the next one.
13
Press the Function
button
,
then press
twice.
14
Use the alphanumeric
keypad to select the
desired Disable Time
Span (for example,
02:00 hours/minutes),
then press
twice to execute the
command.
Comments: The yellow Disabled Function indicator is lit.
All selected points still signalling alarm are disabled. Although points have
been disabled, the system will still be in alarm state.
To reactivate the point(s), you have to enable the points that have been disabled.
15
Press
to move
back to the first level of
the Menu Mode. Repeat
the procedure similar to
step 12 to 16, but
enable instead of
disable the points.
(Points can also be
enabled from the
Disablement window).
The point(s) will again
signal alarm (if reset
has not been applied
to points in alarm).
The internal buzzer on
the operator panel is
turned on.
Comments: The yellow Disabled Function indicator goes off.
The red Alarm indicator starts to pulse.
The red Remote Call indicator is lit (if a FARE output is configured and
applied).
16
To reset the system,
press the green Reset
button .
To Next Page
Loading...
Need help?
General
