7. To change the configuration of the selected ports, in the Multiple Port Configuration
pane, double-click the cell beneath the column heading that represents the
parameter you want to change and do one of the following:
• Select a value from a drop-down list.
• Type a value in the cell.
8. In the Make Selection pane, click Apply Selection.
The changes appear in the table.
9. On the AutoLearn tab toolbar, click Apply to apply the changes to the
configuration.
Job aid, buttons and dialogs on the Multiple Port Configuration pane
Button or dialog
name
Button or dialog Description
Switch/Stack/Ports: Opens the Port Editor
dialog.
Port Editor Provides a list of all ports on
the switch or stack.
• Click OK to accept port
selections and return to
the Multiple Port
Configuration pane.
• Click Cancel to return to
the Multiple Port
Configuration pane.
• Click All to select all ports
and return to the Multiple
Port Configuration pane.
Apply Selection Applies port selections and
parameter changes to the
Multiple Port Configuration
pane and the port data table
for review.
Clear Selection Clears Multiple Port
Configuration selections.
Undo Apply Deletes port changes
applied in the Multiple Port
Configuration pane.
Hide Non-Editable Displays only those
parameters that are
editable in the Multiple Port
Configuration pane for the
selected ports.
User interface fundamentals
50 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
