Downloading a configuration file automatically using ACLI
Procedure
1. Access the Privileged EXEC ACLI mode.
2. Enter the configure network load-on-boot {disable | use-bootp |
use-config} address <A.B.C.D> | <ipv6_address> filename
<name> command to configure a switch or stack to automatically load a
configuration file.
ACLI command job aids
The following table describes the copy running-config command variables.
Variable Definition
{tftp | sftp | usb} Specifies whether to save the file to a TFTP
or SFTP server or a USB mass storage
device.
Note:
Not all switch models have a USB port.
address <A.B.C.D> | <WORD> Specifies the address of the TFTP or SFTP
server.
• A.B.C.D—specifies the IP address
• WORD—specifies the IPv6 address
filename <name> Specifies the configuration file name.
username <WORD> Specifies the username for downloading a
configuration file automatically using ACLI.
[password] Specifies the password for downloading a
configuration file automatically using ACLI.
The following table describes the copy config tftp unit command variables.
Variable Definition
address <A.B.C.D> | <WORD> Specifies the address of the TFTP or SFTP
server.
• A.B.C.D—specifies the IP address
• WORD—specifies the IPv6 address
Configuration files fundamentals
58 Fundamentals December 2011
Comments? infodev@avaya.com
To Next Page
Loading...
