IP Office Installation
Installation Manual Page 96
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
Compliance with FCC Rules
Transmit and Receive Gain Settings for PRI/T1 and Analog Ports
The Gain settings are password controlled for use by qualified installation personnel only and must not
be made available to the end user. The default gain settings of 0dB ensures compliance with FCC part
68 section 68.308(b)(5) and TIA/EIA-IS-968 Section 4.5.2.5. "Through transmission amplification from
ports for the connection of separately registered equipment or from other network connection ports".
Gain setting adjustment by unqualified personnel may result in violation of the FCC rules. Qualified
personnel may adjust gain settings above these levels only where:
1. Measurement is made to ensure that the power levels sent to line at each network interface
connected does not exceed the maximum levels specified in FCC part 68 section 68.308(b) and
TIA/EIA-IS-968 Section 4.5 for that specific interface type.
2. Where gain adjustment away from the default values are made, precautions should be taken to
ensure that the connection of terminal equipment is controlled by qualified installation personnel.
To Next Page
Loading...
