SNMP
Installation Manual Page 105
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
CastleRock SNMPc 5.1.6c and earlier:
For MIBs to be used with SNMPc they must first be copied into its mibfiles directory, which is normally
C:\Program Files\SNMPc Network Manager\mibfiles. MIBs are installed by selecting Config and MIB
Database from the SNMPc menu and then using the Add option and selecting the MIB file from the list
presented to load and compile it. The following MIBs must be installed in the order listed to fully SNMP
manage an IP Office system:
MIB file Source
ENTITY-MIB snmp_mibs\Standard on IP Office Admin CD
AVAYAGEN-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
IPO-PROD-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
IPO-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
INET-ADDRESS-MIB.mib snmp_mibs\Standard on IP Office Admin CD
INTEGRATED-SERVICES-MIB snmp_mibs\Standard on IP Office Admin CD
DIFFSERV-DSCP-TC.mib snmp_mibs\Standard on IP Office Admin CD
DIFFSERV-MIB.mib snmp_mibs\Standard on IP Office Admin CD
IPO-PHONES-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
The MIB installation instructions provided above are correct for CastleRock SNMPc V5.0.8 and later. For
V5.0.1 of CastleRock SNMPc the following must be carried out:
1. Copy all of the IP Office MIBs and standard MIBs from the admin CD to the SNMPc mibfiles
directory.
2. In the SNMPc mibfiles directory open the files STANDARD.mib and SNMPv2-SMI.mib in
Notepad.
3. In the SNMPv2-SMI.mib file find the definition of zeroDotZero and copy this to the clipboard.
4. In the STANDARD.MIB file find the SNMPv2-SMI section and paste in the definition of
zeroDotZero from the clipboard before the end of this section (just before the END statement).
5. Save the modified STANDARD.MIB file.
6. Add the MIB file SNMP-FRAMEWORK-MIB.mib to the MIB database using the instructions
provided in the IP Office installation guide.
7. Add all the MIB files listed in the instructions provided in the IP Office installation guide in the
order given.
8. Compile the MIBs ready for use.
The reason for this is: The IPO-PHONES-MIB.mib relies upon the DIFFSERV-MIB.mib for the definition
of the textual convention of IndexInteger. The DIFFSERV-MIB needs the definition of the textual
convention zeroDotZero which is normally defined in SNMPv2-SMI.mib. However including SNMPv2-
SMI.mib in the MIB file compilation list results in errors due to conflicts with what appear to be internal
definitions within SNMPc and the SNMPv2-SMI section in its STANDARD.mib file. Therefore to resolve
the issue the required definition of zeroDotZero must be placed in the SNMPv2-SMI section in SNMPc's
STANDARD.mib file.
To Next Page
Loading...
