Avaya IP401 - MIB Loading; HP Openview Network Node Manager 6.41 and Earlier

IP Office Installation
Installation Manual Page 104
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
MIB Loading
In order to SNMP manage an IP Office system, that is browse its MIBs and fully interpret the traps it
sends out, the MIBs supported by IP Office must be loaded and compiled for use with your Network
Management System. The supported standard and proprietary MIBs together with the MIB files relied
upon for definitions are provided on the IP Office Admin CD off the directory snmp_mibs. Detailed below
are details of how to install the appropriate MIBs with a number of Network Management Systems.
HP OpenView Network Node Manager 6.41 and earlier:
MIBs are installed in Network Node Manager by selecting Options and Load/Unload MIBs: SNMP from
the menu and then using the Load… option and browsing for MIB files to load and compile. The following
MIBs must be installed in the order listed to fully SNMP manage an IP Office system:
MIB file Source
RFC2737-ENTITY-MIB snmp_mibs\standard on OpenView install CD
AVAYAGEN-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
IPO-PROD-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
IPO-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD
INET-ADDRESS-MIB.mib snmp_mibs\Standard on IP Office Admin CD
RFC2213-INTEGRATED-
SERVICES-MIB
snmp_mibs\standard on OpenView install CD
DIFFSERV-DSCP-TC.mib snmp_mibs\Standard on IP Office Admin CD
DIFFSERV-MIB-HPOV.mib snmp_mibs\Standard on IP Office Admin CD
IPO-PHONES-MIB.mib snmp_mibs\IPOffice on IP Office Admin CD