IP Office Installation
Installation Manual Page 54
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
IP401 Expansion and Installation of Integral Modules
An IP401 Compact Office 2 can be expanded to an IP401 Compact Office 4.
Either unit can also be expanded with addition of a WAN card, a Voice Compression Module 5 (VCM5)
and/or a VME module (providing memory capacity for integral voice mail).
1. CAUTION - While installing modules, ensure that you wear aground wrist strap that is connected
to a suitable grounding point.
2. To add a VME memory card you do not need to de-assemble a module, simply insert the VME
memory card (item (1) ) into the slot in the rear panel below the WAN port position (item (2) ).
3. Remove the top cover (item (3)) from the base cover by removing the four retaining screws (two
either side - items (4)) and proceed as follows.
4. To expand an IP401 Compact Office 2 to an IP Compact Office 4:
• Remove and discard the front panel (item (5)).
• Remove the rear panel (item (6)). Only discard if a WAN module is being fitted (see
below).
• On the rear panel, press out the molding for the additional BRI RJ45 socket (item (7)).
• Plug the expansion board (item (8)) onto it's sockets and stand-off hex. pillars. Ensure
that the additional BRI RJ45 socket slots into the hole in the rear panel (item (7)). Secure
the expansion board (item (8)) with the three retaining screws.
• Mount the new front and existing rear panels if a WAN Module is not being fitted. If a
WAN module is being fitted, see below.
5. To add a WAN module:
• Remove and discard the rear panel (item (6)).
• Fit the new rear panel (with slot for WAN port 27-way D-type, items (6) and (2)).
• Mount WAN Module (item (9)) in position and secure with the two snap-in spacers.
6. To add a Voice Compression Module (VCM5):
• Mount the VCM Module (item (10)) in position.
• Secure with the two snap-in spacers.
To Next Page
Loading...
