IP Office Installation
Installation Manual Page 66
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
Connecting & Checking Two-Wire Telephones
All two-wire devices (POTS) should be tested according to the manufacturer's instructions before
connection to the IP Office system. Connect the two-wire device and make a test call.
Power Fail Telephones and Sockets
All power fail sockets (on IP400 Analog Trunk 16 modules only – see IP400 Analog Trunk 16) must be
tested.
To test a power fail socket
:
1. Locate the socket and check that it is clearly labeled as a power fail socket.
2. Connect a telephone to the socket.
3. With power to the IP Office system switched on, make a test call.
4. Switch the power to the IP Office system off and again make a test call.
5. Switch the power to the IP Office system back on again.
6. Repeat the test for any other power fail sockets.
• Note
Where E911 statuary requirements for discrete location identification of a power fail
phone are required on the transmitted CLI, ensure that the relevant installation
programming is completed.
To Next Page
Loading...
