Avaya IP401 - Snmp; SNMP Functionality; SNMP Agent Configuration

Installation Manual Page 101
IP Office 2.1 40DHB0002USCL Issue 10c (11th May 2004)
SNMP
SNMP Functionality
The IP Office SNMP Agent implements SNMPv1 on a read-only basis for security reasons.
More
• SNMP Agent Configuration
• MIBs Supported
• Trap Generation
• MIB Loading
• HP OpenView Network Node Manager 6.41 and earlier
• CastleRock SNMPc 5.1.6c and earlier
SNMP Agent Configuration
The following operational items may be configured for the IP Office SNMP Agent using the IP Office
Manager:
SNMP Server:
• Enable/disable
• Enabled: the device to respond to SNMP requests and send traps for any associated
events that occur if so configured.
• Disabled: the SNMP agent on the device does not respond to SNMP requests or send
traps.
• UDP Port (default 161)
• Changes the default port value of the SNMP Agent.
• Read-only community
• Community string of up to 32 alphanumeric characters for read-only access.
• Two trap destinations:
• IP Address
• UDP Port (default 162)
• Community string of up to 32 alphanumeric characters.
• Event mask specifying the events the trap destination is interested in receiving
• generic (coldStart, warmStart, linkDown, linkUp, authenticationFailure)
• licence – License Key Server access fault notifications
• phone change – connected phone change notification