Avaya S8400 - Connecting the Cables; 6 a Connecting the Cables (G600)

Chapter 1: Introduction
16 Installing and Configuring the Avaya S8400 Server January 2008
Services access port
The S8400 Server has one port for Services access. This port is off the Maintenance Processor.
Use this port to access the MPC and the server on the S8400AP circuit pack by way of the
Services laptop computer. For more information on connecting to the Services port on the
S8400 and for the location of the Services port on the S8400 Server, Connecting to the server
directly on page 71.
Table 5: Services access on the MPC
on page 16 lists the Services access protocols. The MPC
receives Service requests on two TCP ports, 10022 (SSH access) and 10443 (Secure Web
access).
Note:
Note: With Release 4.0 or later of Communication Manager, Telnet is disabled, so you
must use SSH to access servers after Communication Manager software
Release 4.0 or later is installed.
Table 5: Services access on the MPC
Access
method
Service
requested
IP address TCP
port
Service granted
Services laptop HTTPS 192.11.13.6 10443 Secure Web access to the MPC
Services laptop SSH 192.11.13.6 10022 SSH access to the MPC
Services laptop
SSH 192.11.13.6 22 Secure Shell access to the
server
Services laptop
HTTPS 192.11.13.6 443 Secure Web access to the
server
Services laptop Telnet 192.11.13.6 23 Access to the server
Services laptop Telnet 192.11.13.6 5023 Access to the SAT on the server
Modem dial-in
PPP>SSH Modem IP
address
10022 Secure Shell access to the MPC
Modem dial-in PPP>HTTPS Modem IP
address
10443 Web HTTPS access to the MPC
Modem dial-in PPP>SSH Modem IP
address
22 Secure Shell access to the
server
Modem dial-in PPP>HTTPS Modem IP
address
443 Secure Web access to the
server
Modem dial-in PPP>Telnet Modem IP
address
23 Access to the server
1 of 2