Avaya S8400 - Chapter 6: IP Interface Configuration; SIPI Address Configuration; Programming the SIPI for Static Addressing

Installing and Configuring the Avaya S8400 Server January 2008 45
Chapter 6: IP interface configuration
This chapter covers the following tasks:
● SIPI address configuration on page 45
● Programming the SIPI for static addressing on page 45
● Setting the VLAN and diffserv parameters on page 48
● Verifying connectivity to the server on page 49
● Verifying that the SIPI is translated on page 50
● Upgrading the SIPI firmware version (if necessary) on page 50
● Enabling control of the SIPI on page 50
● Verifying the license status on page 50
You must program the TN8412AP Server IP Interface (SIPI) so that the system does not enter
No License Mode.
SIPI address configuration
The SIPI circuit pack usually uses static IP addressing only. See Programming the SIPI for static
addressing on page 45.
Programming the SIPI for static addressing
You administer the static IP address for the circuit pack directly through the Ethernet port
connection on the faceplate. See Figure 4
.