Chapter 5: IP interface translations
44 Installing and Configuring the Avaya S8400 Server January 2008
2. In the Host field, enter the IP address for the SIPI that is listed in the Location field.
3. Set the IP Control field to y.
4. Verify that all the other fields are populated and submit the form to save the changes.
5. Repeat this procedure for each port network.
Setting the alarm activation level
1. At the SAT, type change system-parameters maintenance and press Enter.
2. In the CPE Alarm Activation Level field, enter none, warning, minor, or major,
according to the customer request.
3. Submit the screen to save the changes.
Saving translations
To save the translations to the hard disk drive, at the SAT, type save translation and press
Enter.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
IP Control? y Socket Encryption? n
Ignore Connectivity in Server Arbitration? n Enable QoS? n
Primary IPSI QoS Parameters
------------ --------------
Location: 1A01 Call Control 802.1p: 6
Host: 172.22.22.174 Call Control DiffServ: 46
DHCP ID: ipsi-A01a
To Next Page
Loading...
