Chapter 4: Server configuration
32 Installing and Configuring the Avaya S8400 Server January 2008
2. Select Delayed Shutdown and Restart server after shutdown.
3. Click Shutdown.
You will be logged off the server when it reboots. You can use ping to verify when the
server is accessible again.
Maintenance Web Pages configuration screens
The following list shows the web pages you may need to complete for manual server
configuration of the S8400.
● Set Identities
● Configure Interfaces
● Configure Switches
● Set DNS/DHCP
● Set Static Routes
● Configure Time Server
● Set Modem Interface
● Configure MPC
The following describes each of the configuration pages:
● Set Identities — Use this page to assign Avaya server host names and to assign server
functions to a physical Ethernet interface. The options are pre populated with defaults, but
should be changed as needed for the customer’s configuration. See Ethernet interface
assignments on page 33 for a guide to assigning functions to Ethernet interfaces.
● Configure Interfaces — Use this page to enter the IP address, subnet mask, gateway,
and speed for the management LAN and control network.
● Configure Switches — Use this page to specify an IP address and optional SNMP
community strings for any Ethernet adjuncts that the Avaya server controls, that are
connected to the server over a private LAN.
● Set DNS/DHCP — Use this page to enable the different devices (endpoints) in your Avaya
call-processing system to communicate over the corporate LAN. Most corporate networks
have one or more domain name service (DNS) servers that associate an IP address with
the name of a device. When you administer the DNS with the Avaya server names, you
can access the servers by name and by IP address over the corporate network.
● Set Static Routes — Use this page only if the network administrator instructs you. If the
administrator does not specify a particular route for the server to send information over the
network, leave the options blank and click Continue.
● Configure Time Server — Use this page to specify the time source that the Avaya server
uses to set the time of day.
To Next Page
Loading...
