Installing and Configuring the Avaya S8400 Server January 2008 41
Chapter 5: IP interface translations
To administer SIPI circuit packs, use a terminal emulation program to issue Communication
Manager SAT commands.
For Communication Manager terminal emulation, use a program such as Avaya Native
Configuration Manager, Avaya Terminal Emulation, or HyperTerminal.
You also can use Avaya Site Administration to issue SAT commands. To administer some of the
features in the latest release of Avaya Communication Manager, you must use the latest
version of Avaya Site Administration.
Perform these tasks to administer SIPI circuit packs:
● Inputting initial system translations on page 41
● Adding media gateways on page 42
● Enabling the SIPI on page 43
● Adding the SIPI to the system on page 43
● Setting the alarm activation level on page 44
● Saving translations on page 44
Inputting initial system translations
1. Open a SAT session. See Using the SAT command line prompt on page 75.
2. Enter translations:
If the system translations were prepared offsite, enter the translations and reset the server.
If the translations are not available, enter minimal translations to verify connectivity to the
port networks.
3. After you enter the translations, type save translation and press Enter to save the
translations to the hard disk drive.
4. Type reset system 4 and press Enter to have the software read the copied
translations.
To Next Page
Loading...
