Applying power to the server
Installing and Configuring the Avaya S8400 Server January 2008
27
Applying power to the server
Note:
Note: The G650 media gateway must have its power turned on before starting this
procedure.
1. Pull the TN8400 circuit pack out far enough to extinguish all LEDs.
2. Carefully slide the circuit pack back into the slot to reboot the system.
Accessing the server
1. Use a cross-over cable to connect your laptop computer to the Services port on the
faceplate of the server.
2. Wait at least 3 minutes after you turn on the server before you start a Telnet session to
access the information on the CD-ROM.
Configuring Telnet for Windows 2000 and Windows XP
The Microsoft Telnet application might be set to send a carriage return (CR) and a line feed (LF)
whenever you press Enter. The Communication Manager installation program sees this as two
separate key presses. If you are running Windows 2000 or Windows XP, you must correct this
setting before you copy the Remaster Program to the solid state disk (SDD).
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to verify that you see the message Line feed mode -
Causes return key to send CR.
5. Type q and press Enter to exit the telnet session.
Installing Avaya Communication Manager
Use a Telnet session to access the information on the CD-ROM.
To Next Page
Loading...
