Avaya S8400 - Page 46

Chapter 6: IP interface configuration
46 Installing and Configuring the Avaya S8400 Server January 2008
Figure 4: Connecting the laptop directly to the SIPI
Note:
Note: Ensure that you have the password before proceeding.
Depending on the operating system on the Services laptop computer, you might need to clear
the Address Resolution Protocol (ARP) cache before entering a new IP address. If you enter an
IP address and your computer cannot connect, try clearing the cache.
1. On your laptop computer, click Start > Run to open the Run dialog box.
2. Type command and click OK to open a MS-DOS Command Line window.
3. Clear the Address Resolution Protocol (ARP) cache in the laptop.
4. To log into the SIPI, use SSH and the IP address 192.11.13.6.
For information on how to use SSH, see Accessing the command line interface of the
server with SSH on page 69.
Figure notes:
1. Services laptop computer
2. PCMCIA Network Interface Card (NIC)
3. NIC adapter cable (if necessary)
4. CAT5 crossover cable to SIPI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4