Chapter 1: Introduction
20 Installing and Configuring the Avaya S8400 Server January 2008
Note:
Note: With Release 4.0 or later of Communication Manager, Telnet is disabled, so you
must use SSH to access the servers after Communication Manager software
Release 4.0 or later is installed.
● A Maintenance Processor Complex (MPC), which is used with the S8400 Server
● A TN2312BP IPSI that is running firmware version 20 or higher
● A TN8412AP SIPI
● A TN2602 IP Media Resource that is running firmware version 212 or higher
● An Expanded Meet-Me Conferencing (EMMC) server
● A SIP Enablement Services (SES) server
● G250, G350, and G450 media gateways
● C360 Ethernet switches
!
Important:
Important: You cannot use SSH with the G700. From within the Linux command line of a
server, you can use SSH to access the G250, 350, and G450, but you must use
Telnet to access the G700.
To Next Page
Loading...
