AVer VC520 Pro - Remote Control

7
Remote Control
Name
Function
1. Camera Select
One remote can control up to 3 AVer
VC/CAM/VB series cameras. You can
use AVer PTZApp to set numbers
associated with each camera, and then
select which camera you would like to
control using the remote.
[Note] If you only have one camera
that requires no additional setting, the
default is camera 1.
If camera 2 or 3 is selected, the remote
will be unable to control the camera.
In this case, please press camera 1 on
your remote.
2. Camera Direction
Control
Use the directional buttons on the
remote to control the direction of the
camera. Press the directional button to
move the camera or press and hold to
continuously pan or tilt.
3. SmartFrame
One-click automatic FOV adjustment
to fit all participants.
Press and hold button on the
remote for 2 seconds to switch the
SmartFraming function between auto
and manual mode; a message (as
figure shown) will display on the screen
to indicate auto or manual mode.
[Note] While in the video conference
meeting, participants must face the
camera for proper face detection
(SmartFrame). Side facial profiles are
not detectable.
4. OSD Menu
Not supported for VC520 Pro.