Avery Dennison MonarchNet2 9855 - IP Address

Configuring the 802.11b/g and IP Settings 2-3
IP Address
The IP (Internet Protocol) Address is a unique identifier for a device on a
network. It consists of four 3-digit numeric fields, separated by periods.
To change the setting, from the Main Menu: Select Setup, Network.
Then follow these steps.
1. Press  or  until you see
NETWORK
 IP Address 
2. Press Enter/Pause. The current setting is displayed, for example:
IP Address
192.0.192.0
3. Press  or  to move through the positions. Press Feed/Cut to
scroll one digit at a time from 0-9. After you display the option you
need, press Enter/Pause.
For example, to change the IP address from 192 to 000, press
 or  to highlight the first position and press Feed/Cut until you
see 0
, then press  to select the next position and press
Feed/Cut until you see 0
, then press  to select the next position
and press Feed/Cut until you see 0
. Press Enter/Pause to save
the setting or press Escape/Clear to exit without saving.
If you enter a series of digits greater than 255 for any segment of
the IP address and press Enter/Pause, the printer does not save
the setting. However, no error appears on the display.
Correct the IP address and then press Enter/Pause to save the
setting.
4. Press Escape/Clear until you see the Main Menu.