Configuring the 802.11b/g and IP Settings 2-15
Factory Defaults
If you reset the print server to factory defaults, the following values are
restored. Some settings may stay the same, depending on your
network configuration.
Description Default
MAC This value is hard-coded and does not change
TCP/IP Enabled
Name PXR_xxxxxx (xxxxxx = the last six digits of the
MAC address.)
IP Address *
Subnet Mask *
IP Gateway *
Boot Method *
Boot Tries 3
Timeout 0 min
Keep Alive 1 min
SSID <none>
LPD banner Disabled
LPD retries Disabled
Port X1
TCP port 9100
WiFi Mode infrastructure
Speed 54
Actual SSID “discover any AP set for broadcast”
Encryption Disabled
Authentication Type Open System
AP density Low
International Roaming Flexible
Regulatory Domain USI (United States, Indoor)
* May keep previous values based on network configuration.
To Next Page
Loading...
