Avery Dennison MonarchNet2 9855 - Using this Manual; System Requirements

1-2 MonarchNet2 Operating Instructions
Using This Manual
Following is a summary of the contents of this manual:
Chapter Contents
1 Getting Started Information you should know before using the
printer.
2 Configuring the
802.11b/g and
IP Settings
Setting communications between your network and
printer.
3 Using a Web Browser Using your Web browser to configure and monitor
your network printer.
4 Console Commands Lists the supported console commands for your
network printer.
5 Using the Smart Relay
System
Explains how to configure a primary and partner
printer.
6 Troubleshooting Common problems and their solutions.
A Specifications Printer and radio specifications.
G Glossary Networking and printer terms and their definitions.
System Requirements
To use the print server for printing from a wireless network, you need an
802.11b/g wireless network. The wireless network consists of either of
the following:
♦ An 802.11b/g wireless enabled computer printing straight to the
printer
(Ad-Hoc mode).
♦ An 802.11b/g wireless access point allowing wireless and wired
Ethernet enabled computers to print to the print server (infrastructure
mode).
To configure and print, you need the following:
1. The MAC address from the label of the print server (for example:
004017023F96).
2. Obtain the following information from your wireless network
administrator: