Using a Web Browser 3-7
Changing the System Setup
Only configure the settings required for your network/printer.
1. On the System Setup tab, set the Flash Storage: Enabled or
Disabled. Flash storage allows packets with “R” or “N” selectors to
be stored in Flash Memory, instead of volatile RAM. Packets stored
in flash memory are saved when the printer is turned off.
2. Set the Speed Adjustment: Default, 2.5, 4.0, 6.0, 8.0 10.0, or
12.0 ips. If you select “Default,” serial bar codes print at 2.5 ips;
parallel bar codes print at 6.0 ips.
3. Set the Power Up Mode: Online or Offline.
4. Select the Prompt Set: English, French, German, Spanish-ES,
Japanese, Portuguese, Italian, Swedish, Spanish-MX, Danish, Dutch,
Finnish, or Norwegian.
5. Set the Monetary Sign: None, USA, UK, Japan, Germany, France,
Spain, Italy, Sweden, Finland, Austria, India, Russia, Korea,
Thailand, China, Euro-Dollar.
6. Set the Secondary Sign: No or Yes.
7. Set the number of Decimal Places: 0, 1, 2, or 3.
To Next Page
Loading...
