3-18 MonarchNet2 Operating Instructions
4. Click Submit at the bottom of the screen when finished.
5. Click Back
to return to the previous screen.
6. Click the Protocols tab.
7. Click Save Re-init Network (on the Protocols tab) before any
changes take effect. Even though you submitted your changes on
the previous screen, they do not take effect until you click Save Re-
init Network. This process takes a few minutes.
Setting Alerts
Alerts and SNMP are supported with the release of version 3.0 or greater
printer firmware. The printer also contains the minimum set required to
be compliant with printer MIB version 2.0 (RFC 3805).
1. Click the Alerts tab to setup the mail server and select users to
receive messages about the printer’s status.
2. Enter the Mail Server IP Address.
3. Enter the Mail Server Port.
To Next Page
Loading...
