Avery Dennison MonarchNet2 9855 - Test Label

2-16 MonarchNet2 Operating Instructions
Test Label
You can print a configuration label if your print server does not have a
test button. The label is best-displayed using 2” wide by 4” long labels.
If the label is too small, some information may print outside the label
edges.
To change the setting, from the Main Menu: Select Setup, Network.
Then follow these steps.
1. Press  or  until you see
NETWORK
 Test Label
2. Press Enter/Pause.
Test Label
No 
3. Press  to display “Yes” and press Enter/Pause. The configuration
label prints.
See “Printing a Configuration Label” earlier in this manual for a
sample label.