4-20 MonarchNet2 Operating Instructions
SET EN SPeed <1/2/5.5/6/9/11/12/18/24/36/48/54>
Sets 802.11b/g wireless speed in megabits per second (Mpbs).
SET EN SSID “<ssid>”
Sets 802.11b/g wireless SSID. Use quotes if there is a space in SSID. This is
case sensitive.
SH EN STATS
Shows the network I/O statistics.
SET EN WEP [DIS/64/128]
Sets wired equivalent privacy encryption level to disabled, 64-bit, or 128-bit.
SET EN WIRED [AUTO/10BASE/100BASE]
Sets the Ethernet speed.
SET EN WPAGROUP [ENABLE/DISABLE]
Selects whether to use the WPA group key mode. When enabled, group keys
are used for data link encryption.
SET EN WPAPSK <WPAkey>
Sets the WPA pre-shared key or pass-phrase. Use 64 hex characters for the
PSK or 8-63 characters for the pass-phrase. This is only valid when
authentication mode is WPA-PSK.
TCP/IP Commands
SET IP [EN/DIS]
Selects whether to use IP-based protocols.
SET IP ACcess [EN/DIS/ALL] aa.bb.cc.dd
[Mask ee.ff.gg.hh]
Allows or prevents specified IP address from accessing print server.
SET IP ADdress
Sets IP address of print server.
SET IP ARP [EN/DIS]
Selects whether to use an IP address with an ARP packet.
To Next Page
Loading...
