Console Commands 4-1
CONSOLE COMMANDS
Use this chapter to configure the Print Server using Telnet.
You must have a basic understanding of the Telnet application.
For initial setup, do not use Telnet, use auto-discover mode.
Once you have the IP address, you can use Telnet or a Web browser.
RSH or REMSH (remote shell) support is available with the release of
version 3.0 or greater printer firmware. Remote shell support is a
common UNIX® application that provides remote command execution
capability for networked devices. For more information, refer to your
UNIX documentation.
♦ You can use Telnet if you do not have access to the MonarchNet2
software.
♦ This chapter also includes information about the Network Packet
(Console Passthru).
Note: The default port is Port 23.
4
To Next Page
Loading...
