4-4 MonarchNet2 Operating Instructions
9. Type INIT and press Enter to save the settings and initialize the
unit.
10. Type EXIT to exit Telnet.
See the following sections for a list of the most frequently used
commands.
Help Commands
For help at any time, type “Help” and a list of available commands
appears. The Help command builds on itself, because for each command
you type, more details appear for each option.
Note: There are help menus for all supported commands. To access a
help menu for a specific command, type HElp <command>.
Syntax: Help set
DEFAULT Set parameters to factory defaults
EN Network Parameters
LOAd Firmware update parameters
PAssword <password> Set console password
PORt <name> . Parameter for port <name>
PROtect <password> Set update password
SERVEr Server and LAT parameters
SERVIce <name> Service Parameters
SNMP SNMP Variables
Syslog Syslog Parameters
DNS DNS Parameters
STRing n "..." BOT/EOT string
IP LPD/TCP Parameters
POP3 POP3 Parameters
SMTP SMTP Parameters
NETWare Netware Parameters
POWERON <delay-sec> Power on delay
Displays a list of the available help commands for “Set.”
To Next Page
Loading...
