Console Commands 4-7
HElp
Displays the list of available commands.
SET
Sets a specified parameter.
SHow
Displays current settings.
INIT
Saves settings and initializes unit.
SAVE
Saves configuration settings.
SET DEFAULT
Sets print server to factory defaults.
SET LOAd [EN/DIS]
Enables or disables firmware reload after exit.
SET LOAd HOst <name>
Sets node name of boot host (NetWare firmware load).
SET LOAd IP aa.bb.cc.dd
Sets IP address of load host (TCP/IP firmware load).
SET LOAd SOftware <filename>
Sets print server’s firmware filename to load.
SET LOAd XModem
Begins XModem serial download of new firmware.
SET PAssword
Sets console password. The user is prompted for old password, new
password, and to verify new password. The default password is access.
Note: The password is case-sensitive.
To Next Page
Loading...
