116
Model E1070 Indicator Service Manual
PROFIBUS-DP
DB9 - Female Rear Panel
Pin No. Signal Pin No. Signal
6 +5.0@100mA 1 +5.0 Vdc
5 Ground 2 Ground
8 -Tx/Rx 3 -Signal
3 +Tx/Rx 4 +Signal
Housing Shield 5 Shield
Appendix C: Network Connections
DeviceNet
Network Bus Rear Panel
Pin No. Signal Pin No. Signal
1 V-Bus Power 1 V -
2 CAN LOW 2 CAN -
3 Shield 3 Shield
4 CAN HI 4 CAN +
5 V + (24Vdc)* 5 V +
BNC bayonet connector for ControlNet
interface when option card is installed. Be
sure to use 50 ohm termination resistor on
network. (Connector A)
RJ-45 connector for Ethernet 10/100
interface
*An external power supply will be used to supply V+
power. Typically this supply will be previously
installed.
To Next Page
Loading...
