12
Model E1070 Indicator Service Manual
Service Menu
The first level of the Service menu is shown in Figure 3. Under these items
you can do most of the configuration and calibration procedures to ready the
indicator for use. Other items are covered in the Supervisor menu covered
later in this manual.
Figure 3
Service menu top level flowchart
Since the whole Service menu is quite large, it has been broken up into its
individual submenus. Each submenu is illustrated in this section followed by
specific instructions for that submenu.
If your system is using analog scales, use the menu shown in Figure 4. If
your system is configured for SensorComm under the Service Menu>Scale>
Source menu item, follow the CAL menu, Figure 15, in the section titled CAL
submenu for SensorComm scale later in this manual.
Figure 4
CAL submenu for analog scales
1. Access the Service menu. . .
CAL is displayed.
2. Press the PRINT key. . .
ZERO is displayed. Use this item to set the zero reference for the
indicator/scale.
Password for the Service menu
is 0701.
While in a menu, the fan
graphs at the top of the display
flash as a reminder.
CAL submenu for
analog scales
ZERO
(Setting Zero Reference Point)
Press the ESC key to abort
calibration.
To Next Page
Loading...
