46
Model E1070 Indicator Service Manual
TEST submenu
The next section of the Service menu is the TEST submenu. See Figure 9.
This menu lets you view indicator information and test the display, keypad,
serial ports, inputs and outputs.
Figure 9
TEST (diagnostic) submenu
ABOUT
(Indicator information)
Follow these steps to access each item in the Test submenu and to under-
stand what they do and how to set them:
1. Access the Service menu. . .
CAL is displayed.
2. Press the UNITS key repeatedly until. . .
TEST is displayed.
3. Press the PRINT key. . .
ABOUT is displayed. Use this item to view the part number and
revision level for the software found in your indicator.
4. Press the PRINT key. . .
The first part of the software part number is displayed.
5. Press the UNITS key. . .
The second part of the software part number is displayed.
6. Press the UNITS key. . .
The software revision level is displayed.
7. Press SELECT key to return to ABOUT.
8. Press the UNITS key. . .
ADC is displayed. This stands for the analog to digital converter
value in mV/Vs.
9. Press the PRINT key. . .
The mV/V value coming into the indicator is displayed.
ADC
(Analog scale test)
To Next Page
Loading...
