Model E1070 Indicator User Instructions 51
5.3 Print Operations
Using Outputs in the
General Weighing
Application
You can use the outputs function if so desired while in the general weighing
application. Follow these steps to setup the outputs.
Output operation in the general
weighing application:
Below Configured Value:
Outputs are ON
Annunciators are OFF
TIU3 Relays are ON
Above Configured Value:
Outputs are OFF
Annunciators are ON
TIU3 Relays are OFF
1. With the indicator powered up, press and hold the SELECT key until…
OP1 is displayed.
2. Press the PRINT key to see a value entry screen…
Press the PRINT key to accept the displayed value or key in a new
value and press the ENTER key to accept. OP2 will be displayed.
3. Repeat for the other outputs. You can skip the displayed output by
pressing the ESC key.
4. After OP3 has been set, or skipped, the indicator will automatically
return to normal weighing mode.
To Next Page
Loading...
Need help?
General
