36
Model E1070 Indicator Service Manual
SERIAL submenu
Follow these steps to access each item in the SERIAL menu and to under-
stand what they do and how to set them:
1. Access the Service menu. . .
CAL is displayed.
2. Press the UNITS key repeatedly until. . .
SERIAL is displayed.
3. Press the PRINT key. . .
PORT 1 is displayed.
4. Scroll through the other choices, PORT 2 and STRING, by using the
TARE or UNITS key and press the ENTER key to accept the displayed
choice. If you choose PORT 1 or PORT 2, continue with the rest of this
step. If you choose STRING, go to the section STRING (Custom print
formats).
All the port configuration items are identical for Port 1 and Port 2
except port 1 has two additional TYPE selections (RS-485 and
485HD). Use the following steps to configure each port.
BAUD is displayed.
Use this item to set the baud rate.
The next section of the Service menu is the SERIAL submenu. See Figure
8. This menu lets you choose the configure the serial ports and create
custom print formats #1-10.
Figure 8
SERIAL (serial communication) submenu
Port 1 or Port 2
The default serial port param-
eters are 9600 baud, 8 dat-
abits, no parity and 1 stop bit.
Stop bits for the serial
communication are preset to
1 stop bit. This is not config-
urable.
To Next Page
Loading...
