Avery Weigh-Tronix evolution Series - Page 37

37
Model E1070 Indicator Service Manual
5. Press the PRINT key . . .
Current baud rate is displayed. Choices are from 300 to 115,200.
Default is 9600.
6. Scroll the choices by using the TARE or UNITS key and press the
ENTER key to accept the displayed choice. .
BAUD is displayed.
1. From previous step 6, press the UNITS key. . .
D-BITS is displayed. Use this item to set the data bits value.
2. Press the PRINT key. . .
7 or 8 is displayed.
3. Toggle between the choices by using the TARE or UNITS key and
press the ENTER key to accept the displayed choice. .
D-BITS is displayed.
1. From previous step 3, press the UNITS key. . .
PARITY is displayed. Use this item to set parity.
2. Press the PRINT key. . .
NONE, ODD or EVEN is displayed.
3. Scroll through the choices by using the TARE or UNITS key and press
the ENTER key to accept the displayed choice. .
PARITY is displayed.
1. From previous step 3, press the UNITS key. . .
C-TROL is displayed. Use this item to set parity. Use this item to
set the handshake control.
2. Press the PRINT key. . .
NONE, RTS or SOFT (Xon/Xoff) is displayed.
3. Scroll through the choices by using the TARE or UNITS key and press
the ENTER key to accept the displayed choice. .
C-TROL is displayed.
D-BITS
(Data bits)
C-TROL
(Handshakecontrol)
PARITY
(Parity setting)
BAUD
(Baud rate)
Service Menu—SERIAL submenu (continued)