38
Model E1070 Indicator Service Manual
ENQ
1. From previous step 3, press the UNITS key. . .
TYPE is displayed. Use this item to set the port mode.
2. Press the PRINT key. . .
Current setting is displayed. These are the choices you scroll
through in step 3:
ENQ This stands for enquire. When an appropriate enquire
code is sent to the indicator, the configured print
format is sent through the port.
B-CAST This stands for broadcast. If this is enabled, the
indicator will send out the configured print format at
the configured rate whenever scale weight is stable.
SMA Scale Manufacturer’s Association protocol. See Table
3.
R-DISP This stands for remote display. If this is enabled, you
can pick the type of remote display info to send and
the rate the info is sent. This choice sends info con-
tinuously, regardless of the motion on the scale.
RS-485 SMA protocol over an RS-485 multidrop connection
(Port 1 only)
485 HD SMA protocol over an RS-485 half-duplex multidrop
connection (Port 1 only)
3. Scroll through the choices by using the TARE or UNITS key and press
the ENTER key to accept the displayed choice. .
If you pick:
ENQ go to ENQ section below
B-CAST go to B-CAST section below
SMA go to SMA section below
R-DISP go to R-DISP section below
RS-485 (for port 1 only) go to RS-485 section below
485 HD go to 485 HD section below
1. With ENQ displayed, press the PRINT key. There are 3 items that can
be changed when the Enquire mode is selected. Use the TARE and/or
UNITS keys to scroll through the following items:
P-ft: Change the print format(s) that will be printed when the
enquire character is received through the serial port. Press the
PRINT key with P-ft displayed. PftX is displayed. The X stands for
the current print format setting. Press ENTER to accept this
format or key in a new format or formats and press the ENTER
key to accept.
POLL: Change the ASCII character that the indicator will respond
to. Press the PRINT key with POLL displayed. The current
character represented as a decimal number will be displayed.
(Example: for a carriage return (Hex: 0D) 13 will be displayed)
Press the ENTER key to accept the character that is displayed or
key in the decimal equivalent for the desired character and press
the ENTER key.
TYPE
(Serial port mode )
Service Menu—SERIAL submenu (continued)
To Next Page
Loading...
