Model E1070 Indicator User Instructions 39
4.2 Supervisor Menu
6. Toggle between the choices by pressing the TARE or UNITS key.
Press the ENTER key when your choice is displayed…
TYPE is displayed.
7. Press the UNITS key…
TRIPS is displayed. Use this to set outputs to follow over/under/
accept or to function as standard outputs.
Target outputs can only be reset
when the scale returns to within the
configured Gross Zero Band.
Gross Zero Band is configured in a
password protected menu. Contact
your local Avery Weigh-Tronix
supplier or distributor for
assistance.
8. Toggle between TARGET and STNDRD by using the TARE or UNITS
key:
TARGET OP1 is Under
OP2 is Accept
OP3 is Over
STANDARD You can configure outputs from weigh mode.
Generally Accept/Reject.
9. Press ENTER to accept the displayed choice…
TRIPS is displayed.
10. Press the UNITS key…
DIV is displayed.
11. To configure how many divisions will be equal to one graduation on
the fan graph, press the PRINT key…
A number is displayed.
12. Press ENTER to accept the displayed number of divisions or enter a
new number and press ENTER…
DIV is displayed.
13. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for this application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the report before clearing all the
information. See step 2 in this section.
14. Press the PRINT key to clear all the information
OR
Skip to step 15…
SURE? is displayed. This is asking if you are sure you want to clear
the information. If you are, press the ENTER key. If you do not want
to clear the data, press the SELECT key…
CLEAR is displayed.
15. Press the SELECT key…
TARGET is displayed.
To Next Page
Loading...
Need help?
General
