35
Model E1070 Indicator Service Manual
Dec HEX Token Application Group Parameter
156 9C DES PLU ID PLU
162 A2 DIS Remote Display Status Miscellaneous
170 AA VER Software Version Number Miscellaneous
173 AD WST Weight Steady Weight
178 B2 PUP Tare associated with the PLU PLU
184 B8 PUT PLU Totals Information PLU
188 BC PCT PLU Count Total PLU
189 BD LST Net Accumulator PLU
190 BE LGT Gross Accumulator PLU
200 C8 DSP(,n) Print the displayed weight Weight OPTIONAL, (ASCII)
Range: (‘2’-‘9’), Indicator Default: ‘6’
215 D7 NULL Null Token Strings
216 D8 ACT Print the active value (‘G’ for
gross, ‘N’ for net, ‘T’ for tare) Weight
242 F2 PWT Peak Hold Weight value Weight
253 FD HEX,xx Following number will be Hex-Codes MANDATORY, (ASCII-HEX)
transmitted by value. Also, Range: (00 – FF), Editor Default: 00
use this selection to
transmit a NUL as well.
254 FE TEX Reserved for future use
as a ‘token extender’ -----
255 FF EOS End of String String
Notes:
These tokens can be optionally followed by an ASCII 2 to 9 to specify the number of weight digits (including
decimal point). If no specifier is given it defaults to 6 digits (+ decimal point) (equivalent to ASCII 6).
Further, parameter values may be ASCII digits (i.e. range ‘0’ thru ‘9’) or DECIMAL values (i.e. range 0 thru 255). In
all cases, parameters consume one byte. In the term/token table parameters are indicated as follows:
Optional, (ASCII) - (,n)
Optional, (Decimal) - (,x)
Mandatory, (ASCII) - ,n
Mandatory, (Decimal) - ,x
To Next Page
Loading...
