34 Model E1070 Indicator User Instructions
Menu Mode
10. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for each application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the reports before clearing all the
information. See step 4 above.
11. Press the PRINT key to clear all the information
OR
Skip to step 12…
SURE? is displayed. This is asking if you are sure you want to clear
the information. If you are, press the PRINT key. If you do not want
to clear the data, press the SELECT key…
CLEAR is displayed.
12. Press the SELECT key…
PLU is displayed.
ACC Application 1. Press the UNITS key…
ACC. is displayed. This stands for the accumulator application.
See Figure 4.2 to reference the
Supervisor’s menu.
2. Press the PRINT key…
PRINT is displayed. Use this item to print out a complete report of
accumulator totals for each PLU similar to the one shown below:
Channel #:
ID: 0
Gross Accum: 0 lb
Net Accum:0 lb
Total:0
3. Press the PRINT key …
PORT 1 or PORT 2 is displayed. Use this item to select which port
to use for printing the report.
4. Toggle between PORT 1 and PORT 2 using the TARE or UNITS key.
Press the ENTER key when the choice you want is displayed…
Display shows BUSY briefly then returns to PRINT.
5. Press the UNITS key…
CLEAR is displayed. Use this item to clear all the information
stored for this application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the report before clearing all the
information. See step 2 above.
To Next Page
Loading...
Need help?
General
