45
Model E1070 Indicator Service Manual
Use the String item to create customized print formats. The default print
format is always = 0 and it is edited under the APP menu item.
Use the STRING menu to create formats #1-10. These formats are called
from application specific settings or from Serial menu item settings.
1. From previous step 5, press the PRINT key. . .
1 is displayed. This is the print format number.
2. Scroll through the list of 1-10 using the TARE or UNITS key and press
ENTER to select the displayed choice. . .
The current destination is displayed. This may be:
Port 1, serial port #1
Port 2, serial port #2
TCPIP1 if you want to send the format(s) through network connec-
tion #1 (net1 must be configured as Enet1 or Enet4)
TCPIP2 if you want to send the format(s) through network connec-
tion #2 (net2 must be configured as Enet1 or Enet4)
SMTP1 if you want to send the format(s) as an email through
network connection #1 (net1 must be configured as Enet1 or
Enet4)
SMTP2 if you want to send the format(s) as an email through
network connection #2 (net2 must be configured as Enet1 or
Enet4)
3. Scroll through the choices shown above by using the TARE or UNITS
key and press the ENTER key to accept the displayed choice. . .
A string is displayed. Refer to the section Extra Info: Print Format
Editing to understand how to edit strings.
4. When you are done editing a string press the ENTER key. . .
The print format number is displayed.
5. Do 6a or 6b:
6a. Repeat steps 2-6.
6b. Press the SELECT key to return to the SERIAL display. . .
SERIAL is displayed. This completes the SERIAL submenu.
7. Press the UNITS key to go to the TEST submenu
OR
press ESC to return to normal operation mode. . .
If you press ESC, SAVE is displayed.
8. Press ENTER to save the changes or the ESC key to abort the save
process and return to normal operating mode.
STRING
(Custom print formats)
Service Menu—SERIAL submenu (continued)
To Next Page
Loading...
