Avery Weigh-Tronix evolution Series User Manual

Model E1070 Indicator User Instructions 53
5.6 Accumulator Weighing
Using Outputs in the
Accumulator Application
If enabled, you can use the output function while in the accumulator
application. Outputs are enabled in a password protected menu. Contact
your local Avery Weigh-Tronix supplier or distributor for assistance. Follow
these steps to set up to three outputs:
Output operation in the
accumulator application:
Below Configured Value:
Outputs are ON
Annunciators are OFF
TIU3 Relays are ON
Above Configured Value:
Outputs are OFF
Annunciators are ON
TIU3 Relays are OFF
1. With the indicator powered up, press and hold the SELECT key until…
OP1 is displayed.
2. Press the PRINT key…
The current value for OP1 is displayed.
3a). Press ENTER to accept this value
OR
3b).Key in a value and press the ENTER key.
OP1 is displayed.
4. Scroll through all three outputs by using the TARE or UNITS key.
5. Repeat steps 2 and 3a or 3b for each output.
6. Press ESC key…
7. Press ENTER to save the changes or ESC to abort the changes…
The unit returns to normal operation mode with the saved outputs
active.
8. As you apply weight to the scale, output one will activate above its
setpoint and deactivate below its setpoint. The same is true for the
other two outputs. When activated each output’s annunciator will light
on the display.

Avery Weigh-Tronix evolution Series Specifications

General

Brand	Avery Weigh-Tronix
Model	evolution Series
Category	Measuring Instruments
Language	English