86
Model E1070 Indicator Service Manual
4. Press the PRINT key. . .
PRINT is displayed. Use this item to print out a complete report of
all application parameters and totals.
5. Press the PRINT key . . .
Port 1 or Port 2 is displayed. Use this item to select which port to
use for printing the report. See note at left.
6. Toggle between PORT 1 and PORT 2 using the TARE or UNITS key.
Press the ENTER key when your choice is displayed. . .
The report is printed and display shows BUSY briefly then returns
to PRINT.
7. Press the UNITS key. . .
TARE is displayed. Use this item to enable multichannel preset
tares.
8. Press the PRINT key. . .
ON or OFF is displayed.
9. Toggle between the choices using the TARE or UNITS key and press
ENTER to accept the displayed choice. . .
If ON is chosen, the tare value for each channel can be entered. 0
will be displayed. Use the TARE or UNITS key to change the
channel number. Press the ENTER key when the correct channel
number is displayed to enter the tare value for that channel.
10. Press the UNITS key. . .
CLEAR is displayed. Use this item to clear all the information
stored for each application. WARNING - Only do this if you are
sure you want the information permanently removed!
You may want to print out the reports before clearing all the
information. See step 4 above.
11. Press the PRINT key to clear all the information
OR
Skip to step 12. . .
SURE? is displayed. This is asking if you are sure you want to
clear the information. If you are, press the PRINT key. If you do
not want to clear the data, press the SELECT key. . .
CLEAR is displayed.
12. Press the SELECT key. . .
PLU is displayed.
Supervisor Menu—(continued)
The PLU report contains the
following information for each
of the 11 channels:
Channel #
ID #
Gross Accum.
Net Accum.
Count Accum.
Total
Tare Value
Lower Limit
Upper Limit
Piece Weight
Cutoff Wt1
Cutoff Wt2
Cutoff Wt3
The scale must be in the
center-of-zero window for the
tare weight to be accepted.
To Next Page
Loading...
