Avid Technology Pro Tools Carbon User Manual

Pro Tools | Carbon Front Panel Operation
15
Device Reset
If you encounter a problem with Pro Tools | Carbon and Avid customer support advises that you reset the device, you can reset to the
default device settings or revert to the default firmware image.
Default Device Settings
If necessary, you can restore the default system settings (such as preamp gain, monitor gain, and so on).
To restore the default system settings for Pro Tools | Carbon:
1 Lower the volume on all output devices and mute your speakers.
2 Power off the unit.
3 Press and hold the Meter button while powering on the unit.
4 Hold the Meter button for 20 seconds while the device front panel is lights in the green start-up state.
5 After this, release the Meter button.
The device starts up with the default settings after the
Meter button is released.
Default Firmware Image
To reset Pro Tools | Carbon to its default firmware image:
1 Lower the volume on all output devices and mute your speakers.
2 Power off the unit.
3 Press and hold the DIM button while powering on the unit. The default firmware will be installed. During this time the device front
panel may not provide any feedback. This process can take up to three minutes. Continue to hold the
DIM button until the device re-
boots itself.
4 Once the device reboots itself, the default firmware installation process is complete. Launch Pro Tools to update the firmware to the
current version.
5 Once this process is complete, launch Pro Tools to update the firmware to the current version.

Avid Technology Pro Tools Carbon Specifications

General

Brand	Avid Technology
Model	Pro Tools Carbon
Category	Recording Equipment
Language	English