Introduction
Avidyne EX500/EX600 MFD -4- 600-00078-001 Rev 05
Note: The message bar displays one message at a time. If more
than one message is available, it will display the highest
priority message first. Press the ACK key to clear the current
message and view those underneath.
6) Radar Bearing Control knob (Brg) - Controls the radar bearing
selection. If you have radar-capable EX500/EX600, see Chapter
4, Radar Page (Optional), beginning on page 33, for more
information.
7) Radar Tilt Control knob - Controls the radar’s Tilt selection. If
you have radar-capable EX500/EX600, see Chapter 4, Radar
Page (Optional), beginning on page 33,” for more information.
8) Data Port - Provides a front panel access point for loading
database updates. For information on database updates, see
Chapter 11 "Updating Your Databases.
Note:When removing the rubber plug from the data port, pull the
cap gently from the right until it pops out. Make sure the
plug is all the way out before you plug anything into the
USB port.
Do not pull too hard on the tab that attaches the plug to
the EX500/EX600. This can separate the plug from the
EX500/EX600 bezel.
9) Range & Cursor Control knob - Allows you to set the Map
range. When other pages are in view, this knob provides cursor
control.
Note: The map range choices change depending on the radar
configured The Map page and Radar page always use the
same selected range; switching between them displays the
same range.
10) Page Control knob - Provides access to the EX500/EX600’s
Map, Radar, TAWS, Chart, Trip, Nearest, Datalink, and Aux
pages. The active page is highlighted in the lower edge of screen.
To Next Page
Loading...
Need help?
General
