Installation Manual
MFD Data Updates P/N 600-00175-000 Rev 04
- 78 -
4. The Dataloader Page shows the progress as it loads the data into the MFD. After loading the data,
the Dataloader performs an integrity check on the data and displays a successful data load
message if all data is valid.
5. When the operation is complete, the EX500/EX600 will continue to the normal startup Page.
6. At this point, turn off power to the EX500/EX600, remove your Portable USB Device, and then turn
the EX500/EX600 power back on.
This step ensures that all data has been checked in self-test and the MFD is ready for use
7. Confirm the valid dates of the Chart data as reported on the Startup Screen.
8. Go to the Chart Page and select a chart from an airport known to be in your subscription coverage
area. Confirm that the chart is available.
9. Store the Portable USB Device in a safe place.
To Next Page
Loading...
