Avocent AMX 5020 User Manual

68 AMX Switch Series Installer/User Guide
2. From the attached serial device, send an fc ‘[TargetUserStationName]’ ‘[servername]’
command to the host user station followed by a carriage return character [0x0D]. This will
force the target user station to connect to the specified target device.
-or-
From the attached serial device, send an
fcc ‘[TargetUserStationName]’ ‘[servername]’
command to the host user station followed by a carriage return character [0x0D]. This will
force the target user station to connect to the specified target device. In addition, the user
station will send a numeric confirmation code indicating the outcome of the command. See
Table 3.6 for code definitions.
To force a user station to break a connection:
1. Make sure that the serial device is configured appropria
t
ely. See Serial parameters on page 67
for more information.
2. From the attached serial device, send an
fd ‘[TargetUserStationName]’ command to the host
user station followed by a carriage return character
[0x0D]. This will force the target user
station to disconnect from the target device.
-or-
From the attached serial device, send
an fdc ‘[TargetUserStationName]’ command to the host
user station followed by a carriage return character
[0x0D]. This will force the target user
station to disconnect from the specified target device. In addition, the user station will send a
numeric confirmation code indicating the outcome of the command. See Table 3.7 for
code definitions.
Confirmation codes
If you use the fcc or fdc commands, you will receiv
e a numeric confirmation code indicating the
outcome of the command. See Table 3.6 and Table 3.7 for confirmation codes and
corresponding definitions.
Table 3.6: Force Connect Confirmation Codes
Code Definition
0
The command was valid. The target device was found and the user has connection
rights to that
target device.
1 Invalid syntax. The command was not entered correctly.
2 The specified target device was not found.
3 The user does not have connection rights to the specified ta
rget device.
4 An invalid command was entered.
AMX.book Page 68 Thursday, June 12, 2008 4:14 PM

Avocent AMX 5020 Specifications

General

Brand	Avocent
Model	AMX 5020
Category	Switch
Language	English